#Ultimaker cura 4.8 0 full
#Ultimaker cura 4.8 0 download

Somewhere above the tool change will be (should be) an M104 line so that If the printing temps are different for extruder 0 than extruder 1 then

Will be an M104 and M109 at the beginning of the file and an M104 S0 at the Need to be a temperature change or warmup around the tool change. If both your materials use the same printing temperature there wouldn't The first line of the Gcode file should give the flavor. Marlin uses M84 to disable steppers and RepRap uses M18 so I'd say it's a I guess since there is just the single color switch it doesn't matter but that isn't even close to being even. Then T1 primes a total of 31 before starting to extrude. Looking at the retractions before tool change - you have a normal retraction after extruding of 10, then a retraction of 130, then a retraction of 5, and finally a retraction of 155 for a grand total of 300mm of retraction of T0 before switching to T1. Although if it was sliced for separate heaters, and if the standby temperature was equal to the printing temperature, it might look the same. So just looking at that snippet it looks like is was sliced for a 'shared heater'. If the printing temps are different for extruder 0 than extruder 1 then somewhere above the tool change will be (should be) an M104 line so that when the tool change comes up the extruder is near the correct temperature. There will be an M104 and M109 at the beginning of the file and an M104 S0 at the end of the file.

If both your materials use the same printing temperature there wouldn't need to be a temperature change or warmup around the tool change. Tell us what you think on the forum.Marlin uses M84 to disable steppers and RepRap uses M18 so I'd say it's a RepRap gcode.

#Ultimaker cura 4.8 0 download

Download it now and get the most modern 3D printing workflow available. Download nowĪll of these features and more are available in Ultimaker Cura 4.3 today.

#Ultimaker cura 4.8 0 full

Read the release notes for a full rundown of changes. This version addresses a number of issues from previous versions, including tray icons remaining after application close, silent mode installation and uninstallation, ‘arrange all models’ and much more. Nubnubbud has added a new theme for colorblind users which makes more distinction between colors, such as the yellow/green line colors in the layer view. A drop down selection box has been added to custom mode, giving you a list of presets to place the z seam on your model.Ĭolorblind assist theme. This is especially useful for small perimeters such as printed holes, as they tend to get ripped away from the build plate easily due to their low contact area.Įasy selector for z seam positions. Z seams are now easier to position on your model, thanks to a contribution by trouch. Smartavionics has contributed a setting which recognizes small perimeters and reduces print speed in order to boost the reliability and accuracy of small printed features. This reduces weak points in your model, at the cost of an additional travel move. Randomize infill start. Randomize which infill line is printed first. Input a set of angles you want lines generated at, and these will be placed sequentially throughout your 3D print. Choose the angle that support-infill and interfaces print at, thanks to a contribution from vgribinchuck.

Support infill/interface line directions. Improve reliability with more precise control over certain aspects of your print. Align faces to the build plate easier than before